Autorun
In this article:
– “Autorun” service description;
– description of operations to enable and disable the “Autorun” service;
– description of the operation of saving the configuration of the “Autorun” service;
Applicability:
– BSP ver. 1.0.0 or higher
Description: the “Autorun” service can be accessed from the “Service Settings” section.
Enabling the “Autorun” service allows the G-Mation P6 to automatically execute scripts stored on external storage media connected to the device itself.
In the “Service Settings” section you can view the current status of the service, “ON” in the case of active service and “OFF” in the case of deactivated service.
Clicking the “Configure” button provides access to the service configuration interface.
The configuration interface of the “Autorun” service is shown below:
The popup displayed allows you to act on the on/off switch to change the enable/disable status of the service; clicking the “Edit” button allows you to change the status of the on/off switch.
By clicking the “Save” button, the current status of the on/off switch (enable and disable, respectively) can be applied to the “Autorun” service;
by clicking “Cancel” you can exit the state change mode, restoring the state previously applied to the “Autorun” service;
at any time you can click the “Cancel” button and remove the service status configuration popup display.