Router

---

In this article:

– “Router” service description;

– description of operations to enable and disable the “Router” service;

– description of the procedure for configuring the “Router” on board the G-Mation P6;

– description of the operation of saving the configuration of the “Router” service;

Applicability:

– BSP ver. 1.0.0 or higher

---

Description: the “Router” service can be accessed from the “Service Settings” section.

Enabling the “Router” service enables the G-Mation P6 to route data packets between different communication networks through the built-in router.

In the “Service Settings” section, the service configuration can be accessed.

Clicking the “Configure” button provides access to the service configuration interface.

The following is the configuration interface of the “Router” service:

Clicking the “Edit” button allows you to enter the parameter editing menu:

By clicking the “Save” button, the current configurations in the table can be applied to the “Router” service;

by clicking “Cancel” you can exit the parameter editing mode, deleting all configurations set;

at any time you can click the “Cancel” button and remove the service status configuration popup display.

GSetup makes the “Router” parameter configuration interface available:

“Destination”: IP address of the destination node of the traffic routed by the router rule;

“Gateway”: IP address of the gateway used for routing traffic identified by the router rule;

“Genmask”: network mask;

“Interface”: reference to the network interface of the G-Mation P6;

“Persistent Rule: [TBD]

At the end of the routing rule table are management buttons:

“Add”: allows you to add a new routing rule to the table; the row thus created is ready to be configured;

“Trash”: allows you to delete the corresponding routing rule;